Search:     Advanced search


Using:
Any of the words entered
All of the words entered
Browse by category:





[CUBASE] How to map the transport buttons of my Laboratory keyboard in Cubase ?

Views: 3131

First, you must configure your Laboratory keyboard to send MMC (MIDI Machine Control) messages:

  • Open The Laboratory MIDI Control Center (update to 1.0.1 or later)
  • Select PLAY button
    • Set Mode to MMC
    • Set CC Number to 2 (CC Number will be the MMC command sent)
  • Select STOP button
    • Set Mode to MMC
    • Set CC Number to 1
  • Select RECORD button
    • Set Mode to MMC
    • Set CC Number to 6
  • ... Please refer to http://en.wikipedia.org/wiki/MIDI_Machine_Control MMC Messages for further details about MMC messages
  • Click "Send to keyboard"

In Cubase  6

  • Open Transport > Project Synchronization Setup > Machine Control Input section
  • Click "MMC Slave Active"
  • In MIDI TimeCode Source Section
    • MMC input :  ALL MIDI Input
    • MMC Device ID : 127
  • Click Start/Stop on your keyboard to check that it works
Others in this Category
document My sustain pedal acts reversely; how to invert it?
document The expression pedal sends inadequate values, however it runs just fine on other MIDI keyboards.
document Windows refuses to recognize the Player/Factory/Laboratory MIDI keyboard, the driver is not detected.
document The pads on the Laboratory keyboard trigger only notes in Scene mode, not audio loops nor FX.
document Which expression pedal to use with the MIDI keyboard?
Most viewed
 
document How to authorize my virtual instrument?
01 Jan, 1970
document How to transfer the license from one com...
01 Jan, 1970
document Error: "No Soft-eLicenser can be found"
01 Jan, 1970
document My question is not listed here, how can ...
01 Jan, 1970
document The plug-in does not appear in Logic Pro
01 Jan, 1970
 
Recent articles
 
document USB
01 Jan, 1970
document How to power my BeatStep
01 Jan, 1970
document How to (re)calibrate the potentiometer-b...
01 Jan, 1970
document synsoacc.dll could not be located on the...
01 Jan, 1970
document [SPARK] Spark Hardware is not recognized...
01 Jan, 1970