Arturia Forums
Harware Legacy versions => Origin => Origin Technical Issues => Topic started by: ckbrooks on November 30, 2012, 04:11:51 pm
-
I am sure I am being daft here, but I am just developing my first multi, and one of the slots is using the "acoustic drum" factory patch, which outputs to each of the three available sequences.
I have created a drum sequence in the multi time and again, and got everything perfectly working with the other two slots, which are running as a split keyboard mode. However, I just can't seem to get the sequence to save properly. It's on P1, and I try to save this using the Sequencer tab and going to the globals section, then I also save the multi using the main save button and also allow the component slots to save too.
Then I change to another multi, and then back to my own new one and the sequence is gone and replaced with something else. Even if I use the sequencer page to navigate to P1 it's still gone.
I wonder if anyone would be kind enough to take me through the procedure, as I rather felt that the printed manual is a little vague on this. Thank you in advance for any guidance you can give. I'm sure that once I understand it properly it will be dead easy!
I'm having an absolutely great time with the Origin and looking forward to the final 1.4 version.
-
Me again.... It's okay, it's working now, it was just me!