Arturia Forums
Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: zedius on February 22, 2013, 06:10:19 am
-
Each slider cap has a thin horizontal line of darker gray plastic across the middle of it. I had one of mine jettison itself today. I didn't notice until I found the piece laying on the minibrute. Luckily I did not throw it out and found where it came from! With a little careful glue, I think I'll be alright, but this was a more difficult fix than the key weights as there is very little room to fit the plastic strip into the cap's slot.
Just want to post this here as a warning to others that if you find a little piece of gray plastic on the floor, check your slider caps!!
On a related note, is there a way I can purchase spare knobs and end caps?
Thanks!
-
I am also suddenly missing a slider cap so I am interested in get a replacement and at least a couple spares. I am so proud of my Arturia Keyboard's appearance it hurts me to see it going without! While I am at it, I would like to buy a couple knobs....just in case. Thanks.
-
Just to bump this...I need another CAP!!!
-
another bump: is there a way I can purchase spare knobs and end caps? Doesn't anyone from Arturia have a suggestion?
-
Please PM David@Arturia, I should be able to help you on this.