Arturia Forums

Controllers => MiniLab => MiniLab Technical Issues => Topic started by: aud_lo on July 30, 2013, 05:28:30 am

Title: Minilab stopped working entirely
Post by: aud_lo on July 30, 2013, 05:28:30 am
Hi all


I purchased my minilab two months ago. Everything was working fine until recently. When I plug in the minilab not only does it not turn on but I get this message saying "Because a USB device was drawing too much power from your computer, one of more of your USB devices have been disabled" (even with nothing else plugged in).
I guess it must be the usb port that is faulty, though I don't recall ever being too rough with it or dropping it. I was wondering if anyone has had this experience or know of good resources so that I can fix the usb port myself.


Thanks

aud
Title: Re: Minilab stopped working entirely
Post by: Dav1d on August 19, 2013, 01:41:58 pm
Are you use it as a "USB 1" or "USB 2" with your computer?
However, try it with several computers.
If still a problem, you can try to use another USB cable.
 :)