Arturia Forums

Hardware Instruments => MicroBrute => MicroBrute - General discussion => Topic started by: chysn on June 07, 2014, 09:56:27 pm

Title: Sequencer Pattern Select at Power On
Post by: chysn on June 07, 2014, 09:56:27 pm

When I power on my MircoBrute and move the Sequencer Play switch to "Play," and then press a key to start the sequencer, it always plays pattern #1, regardless of which pattern is actually selected with the Pattern knob.

If I move the Pattern knob, it starts playing the correct sequence. But at power-on, the Pattern knob does not appear to be checked for its position.

MicroBrute Connect indicates that my firmware version is 1.0.3.2.

Title: Re: Sequencer Pattern Select at Power On
Post by: avantronica on October 05, 2014, 04:13:32 pm

I haven't searched back to see if this is a known bug or discussed previously, but it IS a bug !
You should report it, there are far too many bugs that have been lingering around for many months now, very disappointing