March 28, 2024, 10:58:43 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Gate length in the sequencer isn't right  (Read 1737 times)

Howard

  • Apprentice
  • Apprentice
  • *
  • Posts: 6
  • Karma: 1
Gate length in the sequencer isn't right
« on: February 05, 2014, 07:26:26 pm »
I noticed that the gate length isn't correctly proportional to the step size (see connection software). This is a bit annoying, because although e.g. I can get a nice 75% (long) when step is set to 1/4, I can't make the sequence fast enough. Vice versa for the 1/32 setting: even "long" is much too short when the speed is at minimum.

Otherwise loving the Microbrute :-)

Howard

  • Apprentice
  • Apprentice
  • *
  • Posts: 6
  • Karma: 1
Re: Gate length in the sequencer isn't right
« Reply #1 on: March 11, 2014, 09:46:02 pm »
Bump. OK, if it doesn't annoy anybody else...

Bacon

  • Jr. Member
  • **
  • Posts: 78
  • Karma: 11

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines