March 29, 2024, 12:04:19 pm
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Unable to enable aftertouch option.  (Read 2281 times)

Silverfang

  • Apprentice
  • Apprentice
  • *
  • Posts: 5
  • Karma: 0
Unable to enable aftertouch option.
« on: February 17, 2012, 05:52:04 pm »
I'm having a hard time enabling after touch on the laboratory 61 key. I try to enable it, and even modify its values but nothing happens. I first hit the setup button on the keyboard >then I go to the after touch controls and set the mode to control >I then try to set it to a midi channel, but no matter what channel I set it to, it still goes back to channel one. > From there on I can't adjust ANY value no matter whether I turn the knob or not. This is very frustrating as one of the main reasons I bought the laboratory hybrid synthesizer is because it had after touch otherwise it is a fine midi controller.   

Antoine

  • Hero Member
  • *****
  • Posts: 1.087
  • Karma: 38
Re: Unable to enable aftertouch option.
« Reply #1 on: February 20, 2012, 03:33:53 pm »
Correct path is:

 SetUp > 6/Global

Param: AftTchCh
Value: xx

...where "xx" can be:
  • 01...16: the explicit channel number
  • Lwr: sends on the Lower Channel
  • Upr: sends on the Upper Channel
  • All: sends 2 aftertouch messages, on the Lower and Upper channels
  • Pnl: sends on the Lower or Upper channel, depending which one is highlighted on the keyboard frontpanel.

I presume this should be more documented, so I created a new Knowledge Base article.
ex-Arturian

Silverfang

  • Apprentice
  • Apprentice
  • *
  • Posts: 5
  • Karma: 0
Re: Unable to enable aftertouch option.
« Reply #2 on: February 21, 2012, 02:22:44 am »
Thanks alot it seemed to work, could you point me out to some patches/ presets that use this feature in the analog experience software?

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines