March 29, 2024, 11:03:35 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Sequencer Pattern Select at Power On  (Read 1843 times)

chysn

  • Apprentice
  • Apprentice
  • *
  • Posts: 9
  • Karma: 1
Sequencer Pattern Select at Power On
« on: June 07, 2014, 09:56:27 pm »
When I power on my MircoBrute and move the Sequencer Play switch to "Play," and then press a key to start the sequencer, it always plays pattern #1, regardless of which pattern is actually selected with the Pattern knob.

If I move the Pattern knob, it starts playing the correct sequence. But at power-on, the Pattern knob does not appear to be checked for its position.

MicroBrute Connect indicates that my firmware version is 1.0.3.2.

avantronica

  • Apprentice
  • Apprentice
  • *
  • Posts: 40
  • Karma: 2
Re: Sequencer Pattern Select at Power On
« Reply #1 on: October 05, 2014, 04:13:32 pm »
I haven't searched back to see if this is a known bug or discussed previously, but it IS a bug !
You should report it, there are far too many bugs that have been lingering around for many months now, very disappointing

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines