How To switch between relative/Absolute Mode in KeyLabs
1/ Power on the KeyLab
2/ Click on the "Edit" Switch
3/ Click "Global" on the "edit Parameter/Snapshot - Switches"
4/ Turn the Param Knob until you see:
- Param: KnobMode
- Value: Absolute/Relative
5/ Press the Preset/Value Knob
6/ Click on "Edit" Switch to come out the "Edit Mode"
To make sure your Result is correct
1/ If you turn the Cut-Off Knob
2/ VAL Parameter increase or decrease Values from 000 to 127
1/ If You turn the Cut-Off Knob
2/ VAL Parameter increase or decrease Values from 061 to 067
If this is Not the case, feel free to contact us