V76-Pre - General Questions

catalog image
Do you have questions about the V76-Pre? You will likely find an answer here.

v76 vu meters small

The Red clipping LEDs indicate when the first stage of the circuit is overdriven by the input signal.
The more the LED is lit, the more your signal will be colored by saturation and harmonic distortion. (The equalizers have no effect on input stage.)

The yellow LEDs are monitoring the preamplifier output signal.
Consequently, boost or attenuate the signal with the EQ will affect the Vu Meter.

All our preamps are equipped with an automatic gain compensation.
This allow to properly listen the effect of the preamp processing, without being influenced by a volume change.

v76 pre input gain max small

Stereo & Dual Mono

v76 stereo zoom
Stereo:
This mode is automatically enabled when opening the plugin on a stereo track.
The left side of the preamplifier will affect the left side(L) of your stereo track, while the right side will affect the right side(R).


Dual Mono: In this mode, each of the two channels works independently, as if they were mono channels. Therefore, any adjustments made on one channel will not be followed by the other, and will affect ONLY that channel.


Note: In this mode, unlike the Mid/Side, each channel is processed in Mono mode.

Mid-Side

v76 mid side zoom
Mid (Left track): The adjustments made will affect and be perceived in the center of the stereo spectrum (we can think of it as the mono compatible image).
For example, a boost in the Mid channel will make the sound more “mono” and will affect both channels equally. (L/R)

Side (Right track): Meaning that the adjustments made will impact the width of the stereo image only.
Changes on this channel will increase (+) or reduce (-) the stereo feel of your sound.

Tip: When mixing a track, to avoid phase issues, people use to attenuate the lower frequencies on the Side channel.

Per default, the vu meters are calibrated to reach their 0 value at -18dB.
However, on the bottom right of the interface, you can access the Output LED sensibility menu, and change their calibration from High to Low.
This way, the vu meter range can be adujsted to the type of signal you are working with.

v76 pre vu meters stuck

If you have any further questions, feel free to contact us.